This specification section has been prepared to assist design professionals in the preparation of project or office master specifications. It follows guidelines established by the Construction Specifications Institute, and therefore may be used with most master specification systems with minor editing.

Properties	Unit	Specifications
Thickness	mm	4.00, 6.00, 12.00 +/- 0.3
Length	mm	2440, 3660
Width	mm	760, 1050 +/- 1.0
Warp	mm	Less than 1.5 (Width)
Corner angle	mm	Less than 3.0
Corner damage	mm	Less than 5.0

This technical information is designed to provide support in fabrication, installation and/or to ensure performance of Neonnex® Solid Surfaces.
The information is based on the technical data which Neonnex® Surfaces believes to be reliable and is intended for person or persons having knowledge of this technical area. None of the contents, including but not limited to the instructions, recommendations, graphics, techniques and guidelines should be understood as implying of legal warranty or any type of liability by Neonnex® Surfaces and its affiliates.